Aquamax 390 Stainless Steel Gas Storage Hot Water System Supply and Installed

SPECIAL NOTES: All work to comply with Australian StandardTM Gas Installations, AS5601 – 2004, Electrical Standard AS/NZS 3000 – 2000, Local Municipal Regulations and Manufacturer’s installation instructions. 1. The contractor must check cold water mains supply pressure and if it exceeds manufacturers' recommended maximum, an approved pressure limiting valve MUST be fitted. (Variation must be signed by Customer). See Extras. 2. If the existing HWS is recessed into the wall and the new HWS is suitable to install into the existing opening without any alteration to the opening, the replacement HWS can be installed into this opening. OR 3. If the new unit is not suitable to install into the existing opening or is unable to be installed into the existing opening without alteration, see Extras for an additional cost to seal the opening left in the wall by the original HWS with unpainted fibro cement sheet. Note to all Customers: Veeken Plumbing cannot accept responsibility for any defects that may arise in the existing reticulation system. In the event that defects do arise Veeken Plumbing can rectify at the Customer's own expense.